If you place your weather station in an alley, you could very well get a wind tunnel effect on the anemometer, resulting in erroneous wind data.
If weather station is located under a tree or an overhang, the rainfall data measured by the station will not be correct.
This could be a raspberry pi or almost any other linux box running apache with indilib installed locally.The location weather station is the most important part of Meteostation can be used as a ‘standalone’ weather station for any none observatory use. Digital pin 3 is used for the humidity sensor and analog 0 for the ir radiance sensor.įor the Trinket pro we will also use ground, 5v, RX and TX of the FTDI header, as the Trinket does not support serial console over the USB port. Keep in mind that the SDA and SDL ports are used for the Ir and pressure sensor. I will use the Adafruit Trinket Pro 5v, but other compatible arduinos could be used. This howto will show you how to setup and build the induino meteostation. There is also seldom rain without the detection of clouds. MeteoStation does not have a wind or rain sensor, but can be used in combination with wunderground weather trough Meta weather for an extended weather service. Indi clients will react to alerts and can be configured to close your observatory and stop the imaging session in unsafe conditions. The indilib driver is capable of issuing alerts, like daytime, clouded, frezzing and more. The induino MeteoStation is a complete weather station with arduino firmware, indilib driver and a webinterface with current status and graphs that range back in time from 3 hours to one month.
HOWTO configure, compile, wire, print and assemble the induino MeteoStation
0 kommentar(er)
